- Drawing Set-up -
Note: These settings are optional. Except for the Refresh Rate.
Run Time Title
Enter the title that the drawing
will display at run time. During configuration mode the drawings
title is the drawings file name. You can also use the @TAGNAME
specifiers to modify their titles.
Language
The two buttons here are for
creating and/or accessing language files. They are called Begin and
End. The begin language file is run when the selected drawing is
loaded during run mode, either from configuration mode or from
start-up. The end language file is run when the selected drawing
either returns to configuration mode or is shutdown. If the language
is not used the button will display a red cross. If the language is
used the button will display a green tick.
Refresh Rate
This sets the rate at which the
drawing is updated. The value is in 1/10th of a seconds and is ranged
from 2 to 1000. Therefore, the slowest update rate for example is
2/10th which equates to 200 milli-seconds.
Login layer setup
Pressing this button displays the
dialog box shown below. The login setup dialog allows you to select
which layers are displayed for the selected drawing in each of the
different login levels. This only applies when Data Manager is
switched to run mode.
